How to turn off the DRMFTG burst setting

If the rapid-fire setting has been enabled for some reason, please change the setting by following the steps below or try a firmware update.

01Access Web Config

Connect the USB cable while holding down the Start button, then access 192.168.7.1 in your web browser.

If there is no response

Please try refreshing the page or reconnecting the USB cable.

02Open Add-Ons Configuration

On the Web Config screen, select Configuration → Add-Ons Configuration.

03Disable Turbo

Click Enabled for Turbo to disable it.

04Save

Click Save at the bottom of the screen to save the settings.