FAQ

01DRM JS (Lever Arcade Stick)

DRM JS connection disconnects/not recognized
The USB cable may become unstable due to wear and tear.
Therefore, we recommend regularly replacing the USB cable as a consumable item.
When replacing, please use a cable that supports data transfer, not a charging-only cable.
[Recommended/Compatible Type-C cable (2m or 3m)]
https://amzn.to/46URHOX
Faston terminal cable won't disconnect when changing DRM JS buttons
The cable has a locking mechanism, so it will be easier to pull out by pressing the protruding part of the terminal while pulling.
Only the cable connected to the jump switch has a different type of locking mechanism, so please pinch and pull the metal part or insert a flathead screwdriver into the gap to remove it.
*Do not pull the cable as it may break.
I want to assign a different button to the ↑ button on DRM JS
As with a normal arcade stick, swap the cable connected to the ↑ button with the cable of the button you want to use. For the 30mm version, please see here.
I want to replace the top panel of DRM JS
Please refer to this page.
About DRM JS compatible USB cables
Depending on the shape of the connector, the types of cables that can be used may be limited.
The following USB Type-C cable has been confirmed to work with this product.
[Usable USB Type-C cable (2m or 3m)]
https://amzn.to/46URHOX
✦ ✦ ✦

02Leverless Controllers (Slim / FL)

I want to change the button layout of DRM Slim
Refer here to change the button layout.
I want to make the DRM Slim buttons light up
Refer here for instructions on how to set it up.
I want to change the top panel design of DRM FL
The acrylic of the DRMFTG leverless controller has printing/engraving on the back, so it is not possible to sandwich illustrations with the default top panel.
✦ ✦ ✦

03Connectivity, Settings, Other

Cannot use pass-through function with Wingman FGC2/VX
Wingman FGC2/VX does not support pass-through.
Examples of pass-through compatible devices: Brook Wingman FGC, HAUTE42 Booter5, DRMFTG PS5 compatible version
About firmware updates
Firmware initialization/updates may resolve issues.
Please refer to the steps here.
I want to turn off the turbo setting
Please refer to here for instructions on how to set it up.
Controller not recognized
Please try the following steps listed in the manual.
Device switching (while USB is plugged in):
✕ - Nintendo Switch
○ - PC/XInput
□ - PS3/Dinput
△ - PS4/5 (normally times out in 8 minutes)
Directional buttons don't work
The right stick may be set.
Directional button mode switching:
SELECT + START + DOWN - Normal D-pad
SELECT + START + LEFT - Left analog stick
SELECT + START + RIGHT - Right analog stick
○/Ｘ/□/△ buttons are reversed
This may be set for Switch. Please refer to "Device Switching" above.
Cannot press Medium Punch and Heavy Punch simultaneously
If you play the PC version of SF6 with Switch settings, the above phenomenon will occur.
Please connect with PC settings by plugging in the USB while holding down the ○ button.
The main unit is wobbly
All units are inspected for flatness at the factory, but shifts may occur due to impact during transport.
For DRM JS, adjustments can be made by lightly applying weight to the wobbly corner.
For DRM FL, loosen the screws on the bottom of the unit slightly to adjust.